2005 Tsugami BS20CIII

Buyer should verify equipped list & general specification (Per Brochure)

A video of this machine can be seen at
https://youtu.be/U8b9_SHHM64

Equipped With:
Fanuc 18iTB CNC Control
Backworking tool block: 5-OD/ID and 3-Live
Thread Whirler
Note: cut off holder normally located below live tools on gang slide
was removed to accomodate the thread whirler.

Main Spindle Specifications:
Maximum Bar Diameter 0.787"
Speed Range of Main Spindle 200 to 8,000 rpm
Horsepower of Main Spindle 5.0 h.p.
Indexing C-Axis (0.001 degrees)
Programmable Servo Axis Designations:
"Z1" Main Headstock In and Out 8.21"
"T1" O.D. Tool Slide Up and Down 5.90"
"X1" O.D. Tool Slide Right and Left 2.00"
"X2" I.D. Tool Slide Up and Down 7.90"
Auxiliary Slide Motion:
"Z2" I.D. Tool Slide In and Out
(Synchronous to "Z1") 7.88"
Sub-Spindle Specifications:
Maximum Diameter 0.787"
Maximum Drill Capacity - mild steel 3/8"
Maximum Tap Capacity - mild steel 5/16"
Speed Range (serial interface) 200 to 7,000 rpm
Power Rating 3.0 h.p. ac
Sub-Spindle Indexing 5 degree
Driven Tool Drive Motor Rating 1.5 h.p.
Maximum Speed Cross Tool T10-T12 200-5,000 rpm
Maximum Speed Cross Tool T13 120-3,000 rpm
Number of Tool Stations Front working
6 OD / 4 ID / 4 cross driven
Back working
5 ID/OD, 3 driven
Thread whirler

Machine: 99" x 55" x 94" 6,200 lbs
Coolant/Chip Pan: 54" x 48" x 23" 250 lbs