MARVEL PA10/3

View a video demonstration of this machine by clicking the link below.

https://youtu.be/ZI4J_3n21EY

To the best of our knowledge all details listed below are deemed correct. It
is the buyer's responsibility to confirm all details and we encourage an
inspection of the machine(s) and accessories prior to purchase.

CAPACITY 10" x 12" Rectangle; 10" Round.
BLADE 1.25" x .042" x 11' 6".

BLADE TENSION
Hydraulically controlled tension (30,000 psi) provides consistent square
cutting accuracy. Includes a motion detector that will shut the machine off
should the blade break or stall.

SPEED RANGE
70 - 330 SFPM variable through a frequency inverter drive and heavy duty worm
gear transmission. The broad speed range allows for optimum cutting of a large
spectrum of materials.

HYDRAULIC DOWN FEED
Feed rate and down pressure can be controlled independently for fast, accurate
cutting.

HYDRAULIC SHUTTLE FEED
Length settings of 0 - 16" are selected with a hand-wheel and displayed on a
digital counter. The shuttle comes to positive stops at both ends of the
index, assuring cutoff length accuracy. Repeatability is +/- .005 per index.
Up to 9 cycles are possible using the multi-index system.

MOTORS
Blade Drive: 5 H.P., Hydraulic Pump Motor: 1 H.P., Coolant Pump Motor: 1/8
H.P., Machines are available with either 230 or 460 Volt, 3ph., 60 Hz.

OPERATOR'S CONTROL PANEL
Conveniently mounted on the left hand side of the machine and offers full
control of all machine functions such as; Vises, Blade Speed, Saw Frame,
bundle Clamping, Parts Counter, Shuttle Advance & Retract, Coolant and Work
Light.

PIECE COUNTER
The machine will stop the automatic cycle when the pre-set number of cuts has
been reached.

OUT-OF-STOCK SWITCH
The machine will shut off automatically when material is no longer present in
the rear vise.

BLADE GUIDES
The combination roller bearing and carbide blade guides reduce heat and blade
stress providing longer blade life and accuracies of +/- .002 per inch of cut
material.

FAST APPROACH
Work Height is automatically set allowing the head to rise just enough to
clear the workpiece, reducing the cycle time and allowing for faster cutting
performance.

AUTOMATIC CHIP REMOVAL
The chip auger rotating in the coolant return removes chips quickly and
efficiently, freeing the operator to perform more productive operations.
Coolant is allowed to drain back to the tank before the chips are removed from
the machine.

CHIP BRUSH
Powered from the main drive shaft of the saw, the brush changes speed along
with the blade to assure that chips are being removed from each gullet of the
blade, improving cutting performance and blade life.

FULL STROKING HYDRAULIC VISE JAWS
The front vise jaws are split to reduce the remnant to as little as 2". The
split vise jaws also help to reduce burrs left on the material and are ideal
for bundle cutting. Holding the workpiece on both sides of the blade reduces
vibration, providing more accurate cuts and long blade life. Rear Vise: The
rear vise jaw floats hydraulically to accommodate crooked stock assuring
straight, accurate cuts.

WORK LIGHT
Positioned directly over the work area to provide better illumination of the
cutting area, the work light can be turned on and off independently from the
operator's control panel.

Machine: 95" x 87" x 53" 3,100 lbs
Conveyor table: 60" x 18" x 25" 165 lbs