Cincinnati Monoset Tool & Cutter Grinder

CINCINNATI MONOSET Specifications:

Capacities:

Swing Over Main Slide: 12″
Maximum Distance Between Spindle Nose and Tail Center: 6″
Maximum Wheel Diameter (6,000 ft. per minute, approx.): 3-1/2″
Collet Work Diameter (minimum / maximum): 1/8″ / 1-1/4″

Range:

Longitudinal Movement of Main Slide: 5-3/4″
Offset Slide Movement (either side of center): 2-1/4″
Vertical Slide Travel of wheelhead Above Center: 4-1/4″
Vertical Slide Travel of wheelhead Below Center: 4-1/2″
Transverse Slide Travel of Wheelhead: 7-1/2″
Longitudinal Slide Travel of Wheelhead: 6″
Angular Range of Workhead in Horizontal Plane (workhead swivel base): 235 degrees
Angular Range of Workhead in Vertical Plane (workhead angulard adjustment), above or below centerline position: 40 degrees

Speeds:

Grinding Wheel Spindle (two speeds): 6,000 & 8,000 RPM
Workhead Spindle: 287 RPM

General:

Wheelhead Motor: 1/3 Horsepower, 208-220 / 440 Volt, 3,450 / 2,850 RPM, 1.4 / 0.7 Amps, 60 / 50 Hz
Electrical: 208 Volt, Three Phase, 60 Hz
Overall Dimensions: 54″ x 36″ x 58″ tall

CINCINNATI MONOSET Comes as shown in pictures.